中科远迪化工防腐技术有限公司
主营产品:
2023年08月21日 16:11
用途 |
金属防腐涂料 |
按溶剂类型分 |
油性漆 |
耐水性 |
耐海水 |
包装规格 |
30公斤/桶 |
单件净重 |
30000(g) |
保质期 |
12(个月) |
总固含量≥ |
75 |
干燥时间≤ |
1H(表干)≤24H实干 |
颜色 |
灰色 |
冲击强度 |
≥50KGS |
理论涂布率 |
150G/M2 |
干膜厚度 |
30微米 |
特性:锌粉含量高,有阴极保护作用;防锈性能优异;附着力强.
Feature: A highzinc content and provides cathodic protection; excellentanti-rust properties and strong adhesion.
主要技术指标Technical indicators:项目
Item指标
Indicators漆膜颜色与外观
color and appearance灰色,漆膜平整光滑
Gray, smooth film供货粘度
Availability viscosity具有触变性
Thixotropic使用粘度
Viscosity of usage(30-50)sec/20℃(涂-4杯)(加入固化剂)
(30-50)sec/20℃(Tu -4 cups) (with curing agent)密度(g/cm3)
Density(g/cm3)2.70±0.20
光泽度
Gloss半光或无光
Half light or no-light固体体积含量(ml/kg)
Volume solids200±3%(加入固化剂后)
200±3%(with curing agent)理论涂布率(g/m2)
Theoretical spreading rate150干膜厚度(μm)
Thickness30干燥条件,自然干燥
Drying conditions, natural drying>10℃烘干
Drying<150℃相对湿度
Relative humidity≤85%干燥时间(20℃)h
Drying time表干
Set to touch≤2实干
Completely dry≤24完全固化
Fully cured7d或(1-2)h/(70-90)℃重涂间隔
Recoating interval6h
施工参考ConstructionReference:1、表面处理:表面须经喷砂处理,粗糙度达到SIS Sa2.5级。Surface preparation: Abrasive blasting to SISSa2.5 withthe surface.2、施工说明Construction Description:施工方法
Construction Method粘度
Viscosity配套稀释剂
Thinner空气喷涂
Air Spray(20-30)secH-1无气喷涂
Airless spray(30-50)secH-1滚涂/刷涂
Roller / brush根据需要
RequiredH-13、涂料配套coatings matching:(1)表面经喷砂处理Surfaceby sandblasting(2)底漆:KR-A2 Primer:KR-A2
(3)面漆:KR-A3 KR-A6等
Topcoat:KR-A3 KR-A6 sec.
安全 SAFETY
请注意包装标签上的安全事项。此外, 还应遵守有关国家或当地政府规定的安全法规。避免吸入溶剂蒸汽或漆雾, 皮肤、眼睛不得接触本品。在狭窄处或空气不流通处施工, 必须提供强力通风。尽管通风条件良好也应配戴防护用具。
Packings are provided with applicablesafety labels which should be observed. In addition, national or localregulations should be followed. As a general rule, inhalation of solventvapours or paint mist, and contact of liquid paint with skin and eyes, shouldbe avoided. Forced ventilation should be provided when applying paint inconfined spaces or stagnant air. Even when ventilation is provided,respiratory, skin and eye protection are always recommended when sprayingpaint.特别注意:Special Notice:
本说明书有关数据是在标准条件下取得,实际使用时,环境条件可能与之略有不同,以上数据如有改变,以本公司说明书为准,恕不另行通知。
All information in this product data sheet isbased on standard conditions and slight variation may occur with differentconditions. All information in our company is subject to change without notice.
联系方式