厂家提供可人牌W61-31 有机硅耐200℃高温涂料

W61-31 200℃High Temperature Resistant Silicone Paint

概述：由环氧聚酯改性有机硅树脂，耐温颜料、助剂、稀释剂、固化剂等组成。

Description: Composed of epoxy polyestermodified silicone resin, color pigment resistant to temperature, additives,thinner, curing agent.

特性：具有耐温，耐湿热，防潮，防腐等装饰作用；可长期用于200℃以下湿热工作环境中化工介质侵蚀和300℃以内正常大气耐温考验。

Feature：Withtemperature, heat resistance, anti-moisture, anti-corrosion and otherdecorative effects. Resistantto chemical media corrosion in 200 ℃of the working environment for a long time and within the normalatmospheric temperature 300 ℃test.技术指标Technicalindicators：项目

Item指标

Indicators颜 色

Color各色

Colorways理论涂布率（g/m2）

Theoretical spreading rate(g/m2)底漆

Primer140面漆

Topcoat100-120干膜厚度（μm）

Thickness of dry film(μm)40-60施工参考Construction Reference：1、配比Ration： 双组分 主漆：固化剂=4：1，熟化10~15分钟后使用。Two-component main paint: curing agent=4: 1, using itafter ripening of 10~15minutes. 单组分 搅拌均匀即可使用。One- component stirring uniformly before use.2、涂装间隔(25℃) Coating interval (25℃)底漆：5小时后 Primer: after 5 hours 面漆：24小时后Topcoat: after 24 hours3、表面处理：喷砂或抛除锈达到Sa2.5级，手工除锈达St3级。Appearance preparation: sandblastingor polishing rust to Sa2.5 level, or hand-over St3 level.4、涂装参考coating reference底漆：1~2道 Primer: 1~2 times面漆：1~2道 Topcoat: 1~2 times

安全 SAFETY

请注意包装标签上的安全事项。此外, 还应遵守有关国家或当地政府规定的安全法规。避免吸入溶剂蒸汽或漆雾, 皮肤、眼睛不得接触本品。在狭窄处或空气不流通处施工, 必须提供强力通风。尽管通风条件良好也应配戴防护用具。

Packings are provided withapplicable safety labels which should be observed. In addition, national orlocal regulations should be followed. As a general rule, inhalation of solventvapours or paint mist, and contact of liquid paint with skin and eyes, shouldbe avoided. Forced ventilation should be provided when applying paint inconfined spaces or stagnant air. Even when ventilation is provided,respiratory, skin and eye protection are always recommended when sprayingpaint.

特别注意：Special Notice:

本说明书有关数据是在标准条件下取得，实际使用时，环境条件可能与之略有不同，以上数据如有改变，以本公司说明书为准，恕不另行通知