6W LED恒压/恒流源

PRODUCT SPECIFICATION MODEL : LED CONSTANT CURRENT POWER SUPPLY :CC- WPS-23V-7W All conditions listed below are guranteed at ambient of 25degC, Full Load and Vin=220Vac & 110Vac unless otherwise stated MODELS : SPECIFICATIONS NOTE CC-WPS-23V-7W Input Characteristics Input Voltage Range5VinAC : 110/220V (100V ~264Vac,120~370Vdc) V Input Voltage Frequency freq47 ~ 63 Hz Input Current Iin(max) 0.14A @110Vac;0.1A@ 220Vac A Inrush Current (max) 30A @ 220Vac at cold start A power Factor PF50%(min)@full load Output Characteristics RangeOutput Voltage Vout15-23 V Output Current1Io(type)330 mA Output Power(Max)1Pout7 W Ripple & Noise6 300 mV Load Regulation3 20 mA Line Regulation4 20 mA Temperature drift <1.5% from min to max ambient T % Efficiency 80% typical Protection Over Current Protection OCP90%>At Load &gt; 110% Over Voltage Protection OVP AT&gt;110%zeneer clamp Short Circuit Protection Unit under low power mode, auto recovery upon removal of short. Environmental Specification EMI (Conducted RFI) Built to meet FCC Class A EMI (Radiated RFI) Built to meet FCC Class A Operating TemperatureTa -10 ~ 50degC @100% Load;60degC @70% Load Operating Humidity 20 ~ 90% Storage Temperature -25 ~ 75degC Storage Humidity 10 ~ 95% Cooling Natural Convection Cooled Vibration 1min sweep 0~55Hz, 2G Amplitude, X,Y,Z axis 1hr each Shock <20G Safety Standards Standards Built to meet UL1950,CSA22.2 & EN60950 (Pollution Degree 3) Dielectric Strength Input-Output: 3kV, 1min,In-FG:1.5kV,1min Insulation Resistance Output-FG : >50Mohm,500Vdc Physical Dimension H X W X L20.0*26.0*56.0 Weight 70G Description Open frame with header terminals (AC & DC) Gurantees warranty period 2 year @ 40degC, 100% Load NOTES : 1. Throughout Vin range. Vout must be measured as near as possible to power supply. 3. Iout deviation as Io varies from Vout(min) ~ Vout(max). 4. Iout deviation as Vin varies from 85~ 265Vac. 5. Where UL or CSA is concerned, official rated input voltage range is 100~120Vac/200~240Vac. 6. Noise & ripple measured at the power supply's dc header, terminated with 100uF E-cap in parallel with 0.1uF F-cap. Oscilloscope bandwidth -20MHz. Oscilloscope probe connected with 50ohm cable and terminated with matching impedance at oscilloscope input jack (EIAJ standard). GRE-Optoelectronics *此款电源优点 可耐高温（可在70摄氏度环境下正常运行） 耐高压（4KV）