让利供应上海乐泰574胶水，乐泰胶水574，loctite574

'LOCTITE® 574™ provides the following product

characteristics:

Technology Acrylic

Chemical Type Dimethacrylate ester

Appearance (uncured) Orange pasteLMS

Fluorescence Positive under UV lightLMS

Components One component - requires no mixing

Viscosity Thixotropic

Cure Anaerobic

Secondary Cure Activator

Application Sealing

Strength Medium

LOCTITE® 574™ seals close fitting joints between rigid metal

faces and flanges. The product cures when confined in the

absence of air between close fitting metal surfaces. Provides

resistance to low pressures immediately after assembly of

flanges. Typically used as a form-in-place gasket on rigid

flanged connections, e.g. gearbox and engine casings, etc.

The thixotropic nature of LOCTITE® 574™ reduces the

migration of liquid product after application to the substrate.

TYPICAL PROPERTIES OF UNCURED MATERIAL

Specific Gravity @ 25 °C 1.1

Flash Point - See MSDS

Viscosity, Brookfield - RVT, 25 °C, mPa·s (cP):

Spindle 6, speed 2.5 rpm 70,000 to 120,000LMS

Spindle 6, speed 20 rpm 23,000 to 35,000LMS

TYPICAL CURING PERFORMANCE

Cure Speed vs. Substrate

The rate of cure will depend on the substrate used. The graph

below shows the shear strength developed with time on grit

blasted steel lap shears compared to different materials and

tested according to ISO 4587.

% of Full Strength on Steel

Cure Time

100

75

50

25

0

0 5min 10min 30min 1h 3h 6h 24h 72h

Steel

Aluminum

Cure Speed vs. Bond Gap

The rate of cure will depend on the bondline gap. The following

graph shows shear strength developed with time on grit blasted

steel lap shears at different controlled gaps and tested

according to ISO 4587.

% of Full Strength on Steel

Cure Time

100

75

50

25

0

0 5min 10min 30min 1h 3h 6h 24h 72h

0.05 mm

0.25 mm

0.5 mm

Cure Speed vs. Temperature

The rate of cure will depend on the ambient temperature. The

graph below shows the shear strength developed with time on

grit blasted steel lap shears at different temperatures and

tested according to ISO 4587.

% of Full Strength on Steel'