供应3M180C不透光贴膜

单价：145/米

用途：前打光招牌 车身贴膜 标签标志 可作四丝网印刷

结构：膜：2mil铸造式式烯基础 厚:带胶3-4mil 胶：灰色，压力激活易定位背胶 底纹：94磅聚乙烯背纸

特点：延展性好，适用于复杂表面 可去除 易定位 户外长期

品质保证期：7年

施工温度：10度

Description

3M™Controltac™PlusGraphic Film with Comply™Performance Series 180 is a versatile, removable, 2 mil film with a positionable, pressure activated adhesive to make handling large format graphics easier. It also has Comply performance for easier, high quality installations. This film can be used on flat and corrugated with rivet surfaces.

Advantages· Screen printable· Wide color selection· Lifetime warranty for trailers;

up to 7 years for other applications· Easy to temporarily position during application· Removablewith heat or a chemical systemApplication and End Uses

Film series 180C is intended for making removable, durable graphics when used with the listed Compatible Products in the following applications. These types of applications are warranted by the 3M™MCS™Warranty with the Special Warranty Stipulations when used for automobile or vehicle graphics. See page 5.· Interior and exterior graphics and signs· Commercial vehicle and fleet graphics, emblems or striping· Bus graphicsLimitations of End Uses

We do not normally warrant other applications, but please contact us to discuss your needs or let us suggest other 3M products.

Specifically, we do not warrant this film for the following:· Graphics applied to:- Stainless steel.

- Non-3M films (also see Removal on page 7).

- Substrates that do not have a clean, smooth surface.

· Graphic removal from:- Applications with poor paint-to-substrate adhesion.

- Existing graphics that must remain intact. Damage may occur during removal of film series 180C.

· Graphics subjected to:- Gasoline vapors or spills at gas pumps, automobile fuel-tank ports, or top-feeding, petroleum tankers.

·NOTE: Film used on buses must not be applied so as to restrict the safe use of emergency window exits. See Instruction Bulletin 5.4, Release G, July 2003 or later for details.

Compatible Products· 3M™Screen Printing Ink Series 1900 (line & 4-color)· 3M™Screen Printing Ink Series 9700UV (line & 4-color)· 3M™Edge Sealer 3950· 3M™Prespacing Tape SCPS-2 and SPCS-53X· 3M™Premasking Tape SCPM-3 and SCPM-44XCharacteristicsCharacteristicDescriptionFilmCast vinylThickness2 mils (0.05 mm)without adhesive

3-4 mils (0.08-0.10 mm)with adhesiveColorSee the Color Chart on page 2.Adhesive typePositionable, pressure activated with Comply performance featureAdhesive colorFilms with * in color chart: Clear

All other films: Gray-pigmentedLinerPolyethylene-coated layflat paperApplication surfaceFlat, with and without rivets; corrugated; simple curves,; moderate compound curvesApplication substratesABS resins, aluminum, chrome, glass, fiberglass reinforced plastics, paint (check adhesion to powder-coated or water-based paints)Application temperature rangeFlat surfaces with and without rivets: 40°to 100°F (4°to 38°C)

Corrugated surfaces with rivets:

50°to 100°F (10°to 38°C)RemovalRemovable with heat or chemicals within 7 yearsRemoval temperature50°F (10°C) minimum

(air and substrate)