厂家直销单路网络信号防雷器，4组保护线路，例有8组线保护系列

Single-port network signal SPD

1)Product description:

This product is designed according to IEC standards and relevant national standards. Apply to lightning surge protection of computer data interface or network data system of electronic equipment.

◆It is applied to discharge, clamping,voltage stability principle, to achieve an efficient and reliable anti-shock feature high-voltage pulse and accurate clamping voltage.

◆With advantage of low-volume design,excellent transmission performance, fast response, low insertion loss.

◆It is designed with advantage of large intake capacity and long lifetime.

◆Wiring installation is convenient and maintenance is simple.

◆It is suitable for lightning and surge protection of network servers, routers, network switches, HUB, computer networks,100M Ethernet,IP phones and other devices in the network information terminal line.

2)Product parameters:

TYPE:RJ45/4RJ45/8 Operating Voltage (Un):5V5V Max. Continuous Operating Voltage (Uc): 8V8V Nominal Discharge Current (8/20μ s) (In):5KA5KA Max. Discharge Current (8/20μ s) (Imax. ):10KA10KA Limit voltage (10/700 µ s):≤15V≤15V Interface Model:RJ45RJ45 Protected Core Wire:1,2,3,6 line1～8 line Transmission rate (bit / s):100M100M Insertion Loss (dB):≤0.3dB≤0.3dB Working Environment:Temperature -25°C +70°C;Relative humidity<95%;

3)Product installation:

1. The product is installed between the RJ45 interface signal channels which is at the junction of LPZ01 area and LPZ3 area and the protected device, the output end will connect the protected equipment.

2. All wirings must be solid and be connected by electric .

3. Apply to indoor operation, such as outdoors installation, you must install waterproof shell.

4. Lightningproof grounding should be consistent with lightning protection regulatory requirements, grounding wire should be as thick and short as possible,resistance should be less than 10Ω.The grounding line: BVR ≥ 2.5mm2.

更多产品详细了解请与我们联络