UL CE 认证 高品质恒流LED驱动电源 带调光 150W

FEATURES

l High Efficiency (up to 93%)

l Build-in Active PFC (Typical 0.99)

l Constant Output Current

l Waterproof (IP67)

l Diming Function

l All-Round Protection: OVP, SCP, OTP

SHD150 SERIES SPECIFICATIONS

ModelOutput

Current

(±5%) (mA)Output Voltage

(V)EfficiencyPFNo Load Output Voltage (±5%)(V)Ripple & Noise (V)110V Input220V Input110V Input220V InputSHD150-0350SW350257 ~ 42991.0%93.0%0.990.9644612.9SHD150-0450SW450200 ~ 33391.0%93.0%0.990.9634710.0SHD150-0700SW700129 ~ 21491.0%93.0%0.990.962236.4SHD150-1050SW105086 ~ 14391.0%93.0%0.990.961494.3SHD150-1400SW140064 ~ 10790.5%92.5%0.990.961113.2SHD150-2100SW210043 ~ 7190.0%92.0%0.990.96782.1SHD150-2800SW280032 ~ 5489.0%91.0%0.990.96581.6SHD150-3150SW315029 ~ 4889.0%91.0%0.990.96521.4SHD150-3500SW350026 ~ 4389.0%91.0%0.990.96471.3

NOTE:1. All specifications are typical at 25°C unless otherwise stated.

2. The “Efficiency” & “PF” values are measured atfull load, after the unit is thermally stabilized, otherwise they will be lower about 1%

3. The “Ripple & Noise” values are measured by 20MHz bandwidth oscilloscope and the output paralleled a 0.1uF ceramic capacitor and a 10uF electrolytic capacitor.

ELECTRICAL SPECIFICATIONS

ParameterValuesConditionsINPUTAC Voltage90 ~ 305 VacOperating VoltageFrequencyRange47 ~ 63 Hz PF(110V input)0.99Full load, Vin=110VPF(220V input)0.96Full load, Vin=220VAC Current (110V input)1.6 AFull load, Vin=110VAC Current (220V input)0.75 AFull load, Vin=220VInrush Current65 ACold start, Vin=230VLeakage Current1 mAVin=277V, 50HzOUTPUTTop Output Power150 W Set-up Delay Time1.0 ~ 2.0 s Line Regulation1% Load Regulation3% DIMMING10V Output Voltage10 ~ 11 V 10V Output Source Current0 ~ 10 mA Absolute Max. Voltage0 ~ 12 VOn the 1-10V input pinSource Current0 ~ 10 mAPROTECTOver Voltage Protect1.2 Vo±5% floating deviationLatch mode.The power supply shall return to normal operation only after the power is turn-on again.Short Circuit ProtectNo damage shall ur when any output operating in a short circuit condition. The power supply shall be self-recovery when the fault condition is removed.Over Temperature Protect110°C

NOTE:1. All specifications except “OTP” are measured at 25°C .

SAFETY & EMC COMPLIANCE

ParameterStandardsSafety UL/c-UL, CEUL8750, UL935, UL1012, CSA-C22.2 No.107.1

EN61347-1, EN61347-2-13EMIEN55015EMSEN61000-3-2, EN61000-3-3, EN61000-4-2, EN61000-4-3, EN61000-4-4, EN61000-4-5, EN61000-4-6, EN61000-4-8, EN61000-4-11, EN61547

PRODUCTS INFORMATION

ParameterValuesWorking Temp., Humidity-35°C ~ +60°C; 10 ~ 100% RH non-condensingStorage Temp., Humidity-40°C ~ +85°C; 5 ~ 100% RHMTBF350,000 hoursLife Time75,000 hoursDimensionInches (L*W*H) 7.4*3.46*1.54Milimeters (L*W*H) 188*88*39Net Weight1300g