深圳市微联达科技有限公司
主营产品:
2023年12月16日 13:28
类型 |
AC/DC电源 |
晶体管连接方式 |
单端式 |
产品认证 |
ce |
输入电压 |
100-240VAC(V)V(V) |
输出电压 |
24VDC(V)V(V) |
输出功率 |
120W(W)W(W) |
工作效率 |
83(%)%(%) |
输出纹波噪音 |
150 |
输出电压精度 |
2(%)%(%) |
电压调整率 |
2(%)%(%) |
负载调整率 |
2(%)%(%) |
品牌/型号 |
微联达/CAD1120W-24 |
1.描述(SCOPE):
此承认书适应于CAD10120WZ-24型号的工标电源
The purpose of the document is to specify the functional requirements of a 120WWorking standardswitching power supply
2.输入特性(INPUT CHARACTERISTICS):
2.1输入电压(INPUT CHARACTERISTICS):
额定电压(Nominal Voltage):110~240Vac
调整范围(Variation Range):100~264Vac
2.2输入频率(Input Frequency):
额定频率(Nominal Frequency):50-60Hz
调整频率(Variation Frequency): 47-63Hz
2.3输入电流(Input Current):
当输入交流电压为额定值的下限时,输出电压负载满载,输入交流电流2.8A(2.8Arms max At any input voltage and rated,DC output rated load)
2.4浪涌电流(Inrush Current):
当输出为额定负载,环境温度为25℃,输入240Vac冷态起动电源时的浪涌电流小于30A(30Amps Max. Cold start at 240Vac input, with rated load and 25℃ ambient)
2.5 AC漏电流(AC Leakage Current):
当输入电压240Vac时,漏电流为3.5mA(3.5mA Max At 240Vacinput)
3.输出特性(OUTPUT CHARACTERISTICS)
3.1输出功率(Power Output)
电压
Voltage最小负载
Min.Load负载
Max.Load峰值电流
Peak输出功率
Output Power24Vdc0A5.0A5.0-6.0A120W
3.2负载特性/调整率(Combined Load/Line Regulation):
电压
Voltage最小空载电压
Min. Voltage负载电压
Max.Load Voltage线性调整
Line Regulation负载调整
Load Regulation24Vdc24.47V23.64V±2%±2%
3.3纹波和噪音(Ripple And Noise):
测试条件:在20MHz带宽内测量纹波需在输出端接一个10uF的电解电容并联一个0.1uF的瓷片电容。(The ripple and noise are as follows when measure with Max.Bandwidth of 20MHz and Parallel 10uf/0.1uf,crossed connected at testing point)电压(Voltage)纹波和噪音(Ripple And Noise Max)24Vdc150mVp-p3.4启动延迟时间(Turn On Delay Time):
当输入115Vac和输出负载时,启动时间为2S
2second Max.At 115Vac input and output Max.Load
3.5上升时间(Rise Time):
当输入115Vac和输出负载时时间为40mS
40mS Max.At 115Vac input and output Max.Load
3.6保持时间(Hold Up Time):
当输入115Vac和输出负载时,最小保持时间为5mS
5mS Min.At 115Vac input and output Max.Load
3.7效率(Efficiency):
当输入100Vac和输出负载时,最小81%
81%Min.At 100Vac input and output Max.Load
当输入240Vac和输出负载时,最小83%
83%Min.At 240Vac input and output Max.Load
3.8过冲(Overshoot):
在电源开启或关闭的时候,15%
15%Max.when power supply at turn on or turn off
4.保护功能(PROTECTION REQUIREMENT)
4.1短路保护(Short Circuit Protection):
该电源适配器在短路解除时,能恢复正常工作(The power supply will be auto recovered when short circuit faults remove)
4.2过流保护(Over Current Protection):
过流故障排除后,电源将自动恢复正常工作(The power supply will be auto recovered when over current faults remove)
4.3过压保护(Over Voltage Protection):
当输出电压超过额定电压时,电源将保护,故障排除后不能恢复正常工作(The power supply will not be auto recovered when faults remove
5.环境条件(ENVIRONMENTAL REQUIREMENT):
5.1工作温度(OperatingVoltage Temperature):
-15~45℃,满载,正常工作(Full load Normal operation)
5.2存储温度(Storeage Temperature):
-20~75℃,带外壳(With package)
5.3工作湿度:5%(0℃)~90% (40℃)
5.4振动(Vibration):
1.测试标准:国际电工电子委员会 Operating:IEC 721-3-3M3 5~9Hz,A=1.5mm 加速度(9~200Hz,Acceleration 5m/s2)
6.EMC安全要求(SAFETY AND EMI REQUIREMENT)
6.1安全:符合CE标准
6.2高压(DIELECTRIC STRENGTH):2500Vdc/5mA/60s
7.结构参数(MECHANICAL REQUIREMENT)
7.1外壳(Enclosure):159*98*36mm
联系方式