上海秦威航空光电设备有限公司
主营产品:
2023年08月31日 14:50
产品认证 |
ce |
型号 |
WH-1000 |
工作电压 |
220(V)V(V) |
工作电流 |
5(A)A(A) |
开路电压 |
21(V)V(V) |
短路电流 |
----(A)A(A) |
外形尺寸 |
----(mm)mm(mm) |
电池数量 |
-----(个,只)(个,只) |
参考重量 |
100(KG)(KG) |
最大功率 |
1000(W)(W) |
系统电压 |
DC12-48(V)(V) |
品牌/型号 |
WeLL/WH-1000 |
'上海威豪航标电器有限公司
太阳能户用发电系统配置及介绍
目
录
1、太阳能楼道照明系统
SHSE -CL-2000W system
2、设备使用环境及使用寿命Equipment use environment and service life
3、安装注意事项Installation note
4、工程案例
Engineering case
1、太阳能楼道照明系统1000W SHSE -CL-1000W systemItem 配置WHSE-CL-1000WSolar module
太阳能电池板Type
类型 Poly silicon
多晶硅Max power
功率1000WPBattery
蓄电池Type
类型Lead-acid Maintenance-free Rechargeable
铅酸免维护阀控式Capacity
电池容量500AH/48VCharge controller
充电控制器System Voltage
工作电压48VRated charge and discharge current
额定充放电电流30AInverter
逆变器Type
类型pure sine wave
纯正弦波Continuous OutputPower
持续输出功率1000WSurge Rating
瞬间功率2000WOutput Voltage
输出电压220V/50Hz Control Box
配电箱Material and Function
材料/功能Steel box of zinc-plated and lacquer-coated
AC and DC automatic switching
镀锌钢板喷塑/交、直流电自动切换Mounting Bracket
安装支架Material
材料Galvanized steel
镀锌钢太阳能户用发电系统产品报价 price per unit
单价58000.00(RMB)(可连续7个阴雨天工作)
设备使用环境及使用寿命
Equipment use environment and service life
太阳电池板:输出功率保证20年,客户购买后10年内太阳电池板的输出功率不低于90%,20年内不低于80%。
Solar Module:20-year output power warranty,no less than 90% output power after ten years,no less than 80% after 20 years
逆变器:
使用温度-30℃-+70℃
正弦波,波纹<3%,50/60Hz,效率>85%以上。
Inverter:temperature range:-30℃-+70℃,sine wave,ripple<3%,50/60Hz,efficiency>85%
控制器:
使用温度-30℃-+70℃
效率>85%以上。具备充、放电保护等。
Controller:temperature range:-30℃-+70℃ ,efficiency>85%,with charge and discharge protection
蓄电池:
使用温度:-20℃-65℃.我们设计按照<0.1C的放电速率设计,全年大部分时间处于饱和充电状态,延长电池的使用寿命,正常使用寿命不低于3年。
Battery:
temperature range :-20℃-65℃。It is designed at less than 0.1C discharge rate,most of year in the state of saturated charge,no less than 3-year lifetime on normal condition
安装注意事项
Installation note
1. 在建造光伏发电系统过程中,安装是个很重要的环节。
1. Installation is a very important part in the construction of photovoltaic power generation system。
2. 安装时用指南针确定方位,并应注意在方阵前全天不能有高大建筑物或树木等遮阳光。
3. Using compass to determine direction when installed,be noted that there should be no tall buildings or trees before the square,otherwise the sun will be covered。
4. 仔细检查地脚螺钉及方阵支架等是否结实可靠,所有螺钉接线柱等均应拧紧,不能有松动。
4. Carefully check whether the ground screw and square brackets are solid and reliable。All terminal screws should be tighten,not loose。
5. 方阵安装在房顶上的要采取防火措施。
5. Fir prevention measures should be taken when the square is installed on the roof of the building。
6. 在高处安装的方阵应设避雷针。必要时还需设置驱鸟装置。
7. Lighting rod is needed when the square is in height,the equipment to expel birds is also required when necessary。
8. 阳光下安装时注意不要同时接触组件(尤其是方阵)的正、负两极,以免电击。必要时可用不透明材料覆盖后再接线或安装。
8. Do not touch the positive and negative poles of the component especially the square,in the same time to avoid electric shock when working under sun exposure。Using opaque materials to cover the module before installation it when necessary。
9. 安装组件时要轻拿轻放,严禁碰撞、敲击,以免损坏。
9. Handle the component with care when installation it。Non-collision,percussion to avoid damaging。
10. 注意组件,二极管、蓄电池、控制器等极性不要接反
10. Be sure that do not reversed polarity of the component,diode,batter and controller,ect.
11.蓄电池室、控制器箱体应保持通风干燥、清洁。
11. Battery room and controller box should be kept ventilated,dry and clean。
上海威豪航标电器有限公司
2012年3月
工程案例
图片样式仅供参考
'
联系方式